What is the reason for the collapse of the rear edge and bottom of the automatic glass edger?

With the development of society, it is getting faster and faster. Of course, some industries are also following the society and constantly improving their functions, with the goal of making their products better. Automatic glass edging machine is one of them, so what is the cause of the collapse of the rear edge and bottom of the automatic glass edging machine? Let's analyze it.

1. The edging speed should be appropriately reduced, the splint is worn, and the skin is much better than the glass edging machine.

2. Insufficient water.

3. Uneven distribution of glass grinding volume.

4. The grinding wheel is not sharp enough. The water pipe is blocked. The glass edging machine with high water temperature and the chain is too long.

5. There are bubbles and stones in the original movie. In particular, the stones in the glass can easily break the glass edging machine in the heating part.

6. No dark cracks were found on the edge or opening of the glass. The heating part of the glass edging machine is damaged.

The solution is to adjust the amount of uniform grinding and the amount of water added. The glass grinding volume is too large and the speed is too fast. The above is an introduction to the reasons for the collapse of the foot behind the automatic glass edging machine. I hope it will help you.