CNC glass processing center equipment introduction

If the CNC automatic special-shaped glass edging machine is used for internal bonding, this section is used for flat pressing of insulating glass. This section has upper and lower stepping motors and eight-zone suction cups, which can control the precise bonding of the glass. The flat pressing process is controlled by the hydraulic system, and the active pressing of the enclosed hollow glass is completed in the flat pressing section. The feature of this part is the use of glass center positioning, which can make the parallel pressure of the insulating glass uniform, and jointly improve the working conditions of the equipment.

    If the CNC automatic special-shaped glass edging machine is used for internal bonding, this section is used for flat pressing of insulating glass. This section has upper and lower stepping motors and eight-zone suction cups, which can control the precise bonding of the glass. The flat pressing process is controlled by the hydraulic system, and the active pressing of the enclosed hollow glass is completed in the flat pressing section. The feature of this part is the use of glass center positioning, which can make the parallel pressure of the insulating glass uniform, and jointly improve the working conditions of the equipment.

The positioning principle of CNC glass processing center is:

   Detected by the initial photoelectric switch and the central photoelectric switch entering the section, the hollow glass stops at the center position, and the pressure of this section is controlled by the micro switch. If it is internal lamination or surface internal lamination, this part is used for lamination and flat pressing of insulating glass. The insulating glass production line has two processes: SM1800A, SM2200A and SM2500A are operated by a hydraulic system, and SM1600 is operated by a pneumatic system. The pneumatic system is actively completed in the laminating and flat pressing section, which greatly reduces the structural length of the entire insulating glass production line.

 When using the automatic special-shaped glass edging machine, pay attention to the grinding situation at all times, and compensate for the wear of the grinding wheel in time. Keep the cooling water volume of the water tank satisfied, clean the water quality, prevent burning of grinding wheels and glass, and timely sort out the grinding impurities in the water inlet and outlet pipes, insist on dredging the waterway, and check whether all the stroke switches are working properly and controlled before each shift of grinding work Is the direction correct? If it is inaccurate or the control direction is wrong, stop the machine immediately for inspection, otherwise the machine may be damaged.