Installation steps and detailed process of Zhongdu glass processing center

After buying a glass processing center, many friends are faced with the details of installation. How can they install the glass processing center correctly? The following detailed steps are introduced to everyone, and I hope everyone will study hard. Glass processing center 1. Preparation Early stage: enough space for equipment placement, 380V three-phase power of the corresponding power (need zero line), corresponding specifications of the open cable, circulating sedimentation tank, water pump and water pipe, wheels, sand bricks, slabs, operators. Later stage: corresponding tonnage forklift or small hydraulic truck jack, level meter or horizontal pipe, installation tools, various specifications of feet and gaskets. Two, check Firstly, check whether all parts of the equipment are complete and intact, and whether the number of spare parts is correct. If the equipment is lost or damaged during transportation, communicate with the company and customers in time, deal with it as soon as possible, and contact the company for replacement or replacement if there is a problem with the parts. Three, installation 1. Equipment placement The position of the glass processing center should be reserved at the inlet and outlet ends of not less than the length of the wire frame. If the processing party has special requirements, such as the length of the line, the line size should be used as a reference. There should be a space of not less than 1 meter on the back of the equipment. It is convenient for technicians to maintain and process lines. 2. Leveling The leveling of the glass processing center should be based on the conveyor belt. The four sides of the belt should be measured. If the waterproof of the rear side is considered, the rear feet of the equipment can be raised slightly. (You can use a horizontal pipe or a spirit level to complete the leveling work.) The feet can be cushioned with hard stone or steel plates. First, pad the four corners of the equipment, and then pad the feet in the middle. Because the equipment has a large weight and runs smoothly, If the customer has no special requirements, there is no need to use expansion screws or wrap them with cement. 3. Connect to the power supply If the customer does not arrange electrical wiring, the installer can assist the customer to connect the line from the main switch to the equipment switch. The line machine must distinguish between the three-phase live wire and the neutral wire. For the wired nose, press the wire nose tightly, wrap it up, and insulate it. Adhesive tape and wiring terminals must be tightened. 4. Connect to the water source If the customer does not arrange for a hydraulic takeover, the installer can assist the customer to connect the water pipe from the circulating water pump to the water inlet of the equipment (the corresponding water pipe and switch should be installed according to the diameter of each water inlet) 5. Come on The oil pot of the glass processing center should be filled with lubricating oil, and the external bearings of the equipment should be covered with butter. Four, debugging Turn on the power, if the phase sequence protector is not lit, it means that the three-phase line is connected incorrectly. You can switch the two phases at will. Click on the screen and run the conveyor belt to see if the steering is correct. Turn on the motor spindles to see if the steering is correct and the spindle is threaded. Positive and negative, whether the lifting is normal, whether the pressing wheel is smooth, check the limit, check whether the reference numbers in the touch screen are correct, whether the ammeter is accurate, the special-shaped glass edging machine checks the belt and the steering of each wheel, whether the pressing wheel is flexible, and each wheel enters and exits Whether it is smooth or not is automatically sensitive.