Gaomi Feixuan Machinery tells you how to use the glass edging machine?

 With the development of science and technology, people can not only give full play to the natural advantages of glass, but also adjust its performance to make up for its shortcomings. Let's take a look at how to use the glass edging machine and what processes need to go through to make glass. 1. Precautions when using the glass straight-line edging machine: The working method of the linear edging machine (straight edge machine, round edge machine, beveling machine) is that the front and rear pressure plates clamp the glass and drive its linear motion for grinding. Two points must be paid attention to in use: ①The front and rear pressure plates are connected to the glass. The joint surface of the guide rail should be lubricated frequently, otherwise the normal service life of the machine will be affected due to the premature wear of the front and rear pressure plates and the working surface of the guide rail. Although some models have automatic lubrication devices, you should always check whether the lubrication pipeline is unblocked; ② When clamping the glass, the clamping force should be appropriate. Too loose will affect the grinding quality. Too tight will increase the load of the machine, which is prone to jitter and crawling. When the glass is thinned, it is easy to clamp the glass. The clamping force can be a little bit. The large glass clamp is tested on the machine, that is, the glass is clamped in the middle of the machine, and the glass is moved with both hands in the stopped state, and the clamping force is adjusted to just when the hands can't move. 2. Matters needing attention when using glass shaped edging machine ①Whether the height of the suction cup of the special-shaped machine table is consistent has a greater impact on the grinding effect. During assembly, the manufacturer has carried out self-grinding on the five sets of suction cup seats, and selected the suction cup glue with the same thickness to keep the height of each suction cup consistent, so in general Under the circumstances, do not disassemble and assemble the suction cup. If the suction cup glue is damaged, you must choose the same thickness to replace it. ②After a period of use, the vacuum of the special-shaped machine vacuum pump will decrease due to water intake and other reasons (that is, the suction force will decrease). , So pay attention to check and troubleshoot, otherwise, the machine works under insufficient suction, on the one hand, it will affect the grinding quality, on the other hand, it is also prone to safety accidents. 3. Precautions when using the double-sided edging machine ①The double-side edging machine is an inferior edging machine. It is recommended to fix two or three people to operate to ensure the correct operation. ②When there is an error or failure in the double-side grinding procedure, it is recommended to ask the original manufacturer to send someone to repair and debug it. Under normal circumstances, do not disassemble and repair, so as not to mess up the program and cause production stoppage. 4. Precautions when using the profiling machine ①The profiling of the touch machine has a great influence on the grinding accuracy. The working surface of the template must be made of accurate shape and size, and the smoothness must be high. If it is a special-shaped template, the transition must be smooth. ②When replacing the template and the suction cup, Be sure to maintain the level of the suction cup working surface, otherwise it will affect the grinding quality. In addition to the edging machines introduced above, there are also some edging machines with simple structure and single purpose, such as chamfering machines, small disc machines, polishing machines, etc. There are also some special edging machines that specialize in processing certain products. , Such as car rearview mirror edging machine, wash basin edging machine, etc.