Selection requirements for glass edging machine

The choice of glass edging machine depends on the following points:

Gaomi Feixuan Machinery Technology Co., Ltd.

1. Diagonal positioning device. The cylinder force of the diagonal positioning device is sufficient, the brand is reliable, at the same time, the structure is reasonable and the adjustment is convenient. Otherwise, the service life will be short, adjustment will be difficult, and positioning will be inaccurate.

2. Gear box. 1. The gear box must be thick enough. Because the thickness of the toothed synchronous belt wheel is not enough, when the synchronous belt wheel is used for a long time, it will easily cause the gear box to deform, which will cause poor contact and bevel gear; premature wear and may cause premature damage to the bearing and make the machine It doesn't work well, or even doesn't work. 2. Bevel gear transmission (gear) transmission, the gear is in axial, radial force and normal force in three directions. In order to save costs, some manufacturers have deep groove ball bearings, which is wrong. The transport rail beam is a very important part of the edging machine. Buyers must go to the manufacturer to find out where to buy the material of the conveying rail. If the material is not good or the substitutes cause premature wear, the LED directly in the glass grinding does not meet the quality requirements, or even cannot be processed; at the same time, observe whether the flat conveying guide is flat, whether it is warped, damaged or other undesirable phenomena.

3. Whether the track beam and bearing box are properly designed. If it is unreasonable, the track beam will bend and the guide rail will be bent. The rail beam will be severely closed and bent during the opening ceremony and the guide rail bending beam, and even the drive shaft will never work, increasing the difficulty of maintenance and replacement. 3. Grinding wheel. When purchasing equipment, you must understand the source, brand and configuration of the grinding wheel. The processing stability and high quality of the equipment cannot only rely on the imported high configuration, and the high price of the cover of the grinding wheel must use the domestic grinding wheel. Fourth, the motor slide plate, the motor slide plate can not swing left, right, front and back. There should be no left, right, front, and back swings when the car is sliding, otherwise it will cause the motor to swing, and the glass edging and the glass cannot be handled.