How to clean the powder on the side of the glass edging machine?

     The CNC glass edging machine grinds the corners of the glass into powder to make the glass smoother. However, a large amount of these polished powders will be adsorbed on the glass edging machine every day. Therefore, after the end of the work day, the glass powder adsorbed on the glass-breaking edging machine must be properly removed.

       Long-term processing by CNC glass edging machine will cause cutting dust to adhere to the clamping shaft, chuck and the edging chamber. If it is not removed in time, it will scratch the lens and wear the clamping shaft sealing ring and cause water to enter the machine head. , Clean directly with a brush and water spray container. Enter the machine cleaning mode to clean. This method can also clean the internal water supply pipeline of the machine.  

      When clearing, be sure to operate reasonably in accordance with the operating standards. And because the CNC glass edging machine rotates every day, the lubrication and maintenance of it is also a top priority. Always protect the lubricity of the mechanical shaft so that the glass edging machine can work more smoothly. This will not only increase the work efficiency of the CNC glass edging machine, but also increase the production volume of the company's factory. Because of the proper daily maintenance, the service life of the CNC glass edging machine can be extended enough, which indirectly saves the cost of the company's factory.