What are the factors that affect the efficiency of the glass edging machine?

1. For all newly purchased edging machines, be sure to read the instruction manual before using it. After clearing the transmission principle of the primary device, the functions of various handles, handwheels, electrical buttons, water circuits, and air pedal control valves, and mastering the maintenance and knowledge of the training device, you can operate on the machine.

2. The good ring of the grinding head of the glass edging machine has a great influence on the quality of glass grinding. The position and movement gap of the grinding head have been adjusted before leaving the factory. When using, remove the advancing and retreating grinding head, and the rest is glue. Do not move, so as not to affect the grinding quality. In addition, the back position of the grinding head is not easy to be too large, otherwise the waterproof cover will be easily damaged, causing water leakage, and the motor is likely to burn out.

3. Adequate cooling also has a greater impact on the grinding effect. Always check whether the cooling pipeline is blocked. Especially the pipeline of the linear edging machine is easy to be blocked by the bristles, and it is not easy to be noticed after blocking, which will cause insufficient cooling and affect the quality of edging.

4. The CVT used by the edging machine must be in the open state when adjusting the speed, otherwise the CVT of the edging machine will be easily damaged. —All the following preparations have been made in advance, and there may be other factors:

     Manufacturing (process) factors, although the design is correct, but the process manufacturing conditions cannot meet the design requirements, the equipment undergoes various tests and various difficulties and causes the shutdown. Such as cracks in the manufacturing process; unwelded, hot and cold cracks in the welding process are indeed loose and slag inclusions; the dimensional tolerances and surface roughness of machining are not suitable; defects in the heat treatment process, such as quenching cracks, tempering embrittlement, and hardened surface The structure defects, insufficient hardness, too thin hardened layer; finishing grinding cracks.

1. There is a problem with the quality of the glass edging machine. For example, although the process of the edge grinding machine is reasonable, because the manufacturing conditions cannot meet the design requirements, various failures of the equipment will lead to failure. In the forging process, the crack welding process is not in place, hot and cold cracked castings, porosity, slag inclusion; machining tolerances and surface roughness are inappropriate" defects in the heat treatment process, such as cracks, temper embrittlement and hardened surface Defects, hardness, hardening, local overstrike; fine grinding of cracks. Then how should we choose a glass edging machine correctly? Please click for details to view the precautions

2. The material selection factors of the edging machine, the materials used in the parts of the equipment do not meet the technical conditions of Taiwan, and the voids inside the material are the source of internal stress concentration. Under the action of external load, the material ages and the stars appear high stress, which leads to its failure. The effectiveness of material synthesis may be due to improper design and material selection; it may also be caused by defects in the process of cold and hot processing (especially heat treatment) of the blank, and improper installation and debugging.

3. The factors of machine operation and maintenance, first of all, are the monitoring of operating condition parameters (load, speed, etc.) to see if it meets the specified requirements. In addition, lubrication conditions are also an important factor. "Lubrication conditions usually include: whether the lubricant and lubrication method are selected properly, whether the lubrication device and the cooling, heating and filtering system function normally, this is also a glass edging machine There is a daily maintenance problem.