Operation guidance of glass edging machine

      Any machine must check the corresponding things during operation, so as to ensure that there are no problems or failures during use. This is an aspect that cannot be ignored. The glass edging machine is also the same, so the glass What are the 9 points of special attention in the operation guide of the edge grinding machine?

1. The product can be processed only after the cutting edge of the conversion grinding wheel.

2. The grinding amount and the feeding speed must be reasonably matched to avoid damage to the glass.

3. Uncover the glass from the outside to the inside. You can't take any piece of glass from the inside.

4. Check the appearance scale and quality of the edging glass, and the unqualified products will not flow into the next process.

5. Special-shaped edging should be processed strictly according to the example or geometrical figure according to the request of customers, so that the grinding surface is smooth and bright.

6. Fine glass with high requirements for appearance quality, and appearance requirements for original glass that should exceed or be equal to automotive grade glass.

7. When grinding large sheets of glass, if the layout exceeds 3m2, use hooks and suction cups. When multiple people lift the glass edging machine, they should not run, and the walking pace should be stable.

8. Grinding amount control: Grinding amount below 8mm<2.5mm, 10-19mm grinding amount<1.5mm; Feeding speed: below 8mm speed <2.5m, 10-19mm speed <1.5m.

9. Glass accumulation after edging: When the specifications (length × width) are not the same, paper barriers (paper about 100mm × 200mm or string) should be added at the junction of the edges to prevent the glass from scratching.