What should I do if the glass special-shaped edging machine alarms?

      I believe that many customers have encountered unexplained problems with the alarm sounding of the glass shaped edging machine. In fact, these are minor problems. If everyone can self-check to find out the problem and solve the problem, then you don’t need to worry. When the after-sales personnel of the machine manufacturer come to the door, the production will be smoother. The following is an introduction to the troubleshooting method of the alarm failure. Glass edging machine 1. ALO07 motor overspeed alarm, first check whether the machine is stuck and whether the speed is overspeed. 2. ALO09 position error alarm, same as above. 3. ALO06 overload alarm: check whether the power line UVW is connected; check the machine. Glass edging machine 4. AL011, ALO24; ALO28; ALO26 coding signal alarm, first check whether the motor parameters match, then check or replace the coding line, and then check or replace the motor. Glass edging machine 5. AL003 (under voltage) and ALO02 (over voltage) alarm, check whether the input power voltage is normal. If the exterior is normal, replace the drive. Glass edging machine 6. AL001 over-current alarm, check whether the wiring state of the motor and the driver or the conductor body is short-circuited, as well as the wiring sequence of the motor and the driver, and whether the temperature of the heat sink is abnormal. 7. ALO04 motor matching abnormal alarm, check whether the motor and the driver are consistent, if it does not correspond, set the parameters of the driver to correspond to it. 8AL31 Motor U, V, W wiring error alarm, motor POWERLINE UNW.GND wiring error, please connect the wires according to the color, red (U), white (V), black (W) in sequence, three wires are locked on the driver On the motor output block.