Summary of failures and solutions of glass edging machine

1. Question: The center of the lens grinded by the active edging machine shows traces. What is the reason? Answer: This is because the suction cup of the glass edging machine is too tight (the suction cup on the top rubber on the right side of the lens is too tight when entering the lens); it is normal after the suction cup is replaced.

2. Question: What should I do if the lens of the glass edging machine runs off when edging? Answer: 1) Try adjusting the lower level of the edging machine; 2) Paste a plastic film, and then use a special suction cup to avoid deviation.

3. Question: The lens is worn out, but the lens cannot be taken out. What is the reason? Answer: The optician in the optical shop sometimes encounters this kind of problem. After the lens is polished, the lens cannot be removed. It is still necessary to use professional tools to solve the problem. There is a suction cup dismantling pliers on the market now.

4. Question: I cannot grind sharp edges, the glass edging machine head moves the card, the moving belt buckle is loose, the drain is blocked, the main motor belt is broken, and the transmission is not smooth. What should I do? Answer: Replace the head bearing of the edging machine, replace the drive belt, replace the 6805 bearing, replace the main motor belt, and clean the whole machine.

5. Question: What is the condition of the sharp edges not being sharpened? Answer: Replace the mobile motor.

6. Question: What is the reason for the uneven groove division of the sharp edges of the whole frame? Answer: Adjust the level, adjust the nose to move and refuel, and adjust the tip to the function that the guest wants.