Comparison of automatic glass edging machine and semi-automatic glass edging machine

    Automatic glass edging machine can be divided into two types: automatic glass edging machine and semi-automatic glass edging machine. The full-automatic glass edging machine is based on the template to carry out the imitation edging, and the semi-automatic glass edging machine is to carry out the full-automatic glass edging machine according to the computer-scanned mirror circle or three-dimensional data information (invisible edging). The actual operation of the automatic glass edging machine can be divided into three processes 1. Template making Make a template. Draw straight lines on the sample photo and remove the sample photo from the glasses frame. The straight line of the template is parallel to the straight line on the sample photo, and the sample photo is overlapped with the center of the template geometric figure, and the template is laser cut with scissors or a knife head. Take out the grinding plate, file the edge of the grinding plate flat with a file, and at the same time check and repair the same with the mirror ring. 2. Centering Set the center, calculate the shift of mind based on the prescription. Adjust the ruler of the centering instrument (center plate) to the required centering position. Install the glass suction cup and double-sided tape, pay attention to the installation direction. Point the production and processing logo of the lens to the center shifting position, level at three points, and gently press it down to bond the lens and the glass suction cup. 3. Edging For edging, install the grinding plate on the equipment, key the position of the hand, distinguish the eyes, and tighten it to make the grinding plate immobile. Pay attention to the orientation of the glass suction cup when installing the lens. Adjust the actual operation control panel, touch the buttons on the actual operation panel (no need to continue function keys), select the sharp edge type, lens material, circulation system method, production and processing specifications, etc. Press the gradual key to run the equipment. After the sand wheel group moves and the water is discharged from the drain, the swing arm is lowered, and the equipment gradually laser cuts the lens. After rough grinding, it is fully automatic and gradually fine grinding. After the fine grinding is carried out, the equipment will emit a beep warning sound. After pushing up the lower swing arm, remove the lens. If the lens size is not suitable, the equipment on the lens can be finely ground again until it is suitable and the glass suction cup is taken out after it is suitable.      Since the production and processing of the lens has completed the change from the technical professional method to the actual operation of the fully automatic equipment, a fully automatic mold-free computer edging machine has emerged at the right time. Mold-free, generally known as mold-free production, uses a scanner to scan the glasses frame, and then transfers it to the computer to carry out the data processing method to load the glasses frame, and then immediately start the lens work. Below, I will carry out a multi-faceted comparison and analysis of the automatic edging machine and the automatic edging machine, so that the myopia retail store can more strongly select and integrate its own models.       As the production equipment for contemporary myopia products, the automatic edging machine has a significant improvement in edging precision, high efficiency of production and processing, and reliability. Acceptance by optical shops is the development trend of contemporary production equipment. In addition, a universal automatic edging machine will be introduced in the Chinese market to benefit large, medium and small retail stores.