Accuracy inspection standard of glass edging machine

      Before installation, place the opening and closing guide rail and the conveyor belt guide on the first-class tablet computer, and check the parallelism and flatness with a feeler gauge and inner diameter dial gauge. The parallelism and flatness should meet the performance parameter specifications, and the candle holder international dry-running grinding wheel motor to ensure no jump Understand and turn the shaft into compliance with the regulations.

     After the opening and closing guide rails are installed, install the inspection double rocker, take one guide rail as the standard, and check the flatness deviation with a flat ruler and a feeler gauge to meet the relevant regulations.

     After the entire machine is installed, run in for 30 minutes, and the reciprocating mobile phone can be spaced three times at random. At the minimum opening degree, use the inner diameter dial gauge to check that the opening and closing movement repeat accuracy should meet 0.5mm.

Load test standard:

       The compliance experiment shall be carried out after the international air-lifting experiment and accuracy inspection reach the standard. Take three kinds of thin and thick three kinds of glass specimens in the production and processing category to carry out cutting production and processing, and inspect them according to the entire mechanical characteristics.

Inspection standards for the accuracy of production and processing products:

1. Use a feeler gauge to inspect the glass specimen, and carry out the inspection according to the total edge width of the glass grinding dimensional tolerance value, and use a micrometer to accurately measure the total edge width error to meet the corresponding standard value.

2. Use a meter ruler to check the diagonal error of the glass specimen.

3. The inspection of the actual appearance of the glass after production and processing should be carried out under good sunlight or flashing sunlight. The distance between the glass and the front face is about 300mm to observe and inspect the glass edge of the inspected glass. The knife mark scratches are selected as 0.1 mm reading microscope measurement.