The influence of glass size and processing difficulty on glass double-sided machine manufacturing technology

     Here, for the time being, engineering architectural glass represents large-size glass, and electronic appliance glass represents small-size glass as an example. Except in special circumstances.

     In terms of application requirements, large-size glass such as engineering and architectural glass does not require high edging, such as polishing and diagonal lines.

      Small-size glass such as electronic and electrical glass has relatively higher requirements for edging, such as clear and bright cut, uniform chamfer size, sharp edges and corners, and the diagonal should be within 0.2mm. Therefore, we can see that because the processing requirements for small-size glass are higher than that for large-size glass, the processing difficulty of small-size glass is also more difficult than that of large-size glass.

In terms of processing technology, small-size glass is also more difficult than large-size glass.

The reasons are as follows:

        The double-sided edging machine for processing large-size glass can be equipped with a large glass double-sided machine timing belt; while the double-sided edging machine for processing small-size glass must be equipped with a small double-sided edging machine timing belt, and the smaller the glass, the synchronization The belt is also smaller. This results in the difference in the stability of glass conveyance between the two specifications of glass during edging. Due to the self-weight of large-size glass, the large glass and the large timing belt make the contact area between the large-size glass and the timing belt large, so the transmission stability of the grinding force of the large-size glass is good, thereby reducing the technical difficulty of manufacturing the double-sided edging machine. . The small size glass is light in weight. The small size of the glass and the small timing belt make the contact area between the small size glass and the timing belt small, so the transmission stability of the small size glass edging is poor, which increases the technical difficulty of the manufacturing technology of the double edge edging machine. It is to improve the conveying stability of small-size glass edging by other means.

         In this way, large-size glass requires low use and processing technology requirements; while small-size glass requires high use and processing technology requirements are also difficult, which can be said to be a high degree of difficulty. If the technology of the ordinary double-sided machine is adopted, it will not meet the requirements for the use of small-size glass at all. Above all: The manufacturing technology of precision small glass double-sided edging machine is very difficult. If a glass double edging machine manufacturer has mastered the technology of precision small glass double edging machine, you should not think that it has problems with ordinary double edging opportunities.