What are the factors that affect the efficiency of the glass edging machine?

1. For all kinds of newly purchased edging machines, be sure to read the instruction manual before use. After understanding the transmission principle of the primary device, the functions of various handles, handwheels, electrical buttons, waterway and airway regulating valves, and mastering the machine's male maintenance knowledge, you can operate the machine.

2. The failure of the grinding head of the glass edging machine has a great influence on the grinding quality of the glass. The position of the grinding head and the moving distance have been adjusted before leaving the factory. When using, except for the advancing and retreating grinding head, the rest Do not move the strands, so as not to affect the grinding quality. In addition, the retreat position of the grinding head is not easy to be too large, otherwise the waterproof cover will be easily damaged, causing water leakage, and it is easy to burn the motor.

3. Adequate cooling also has a greater impact on the grinding effect. Always check whether the cooling pipeline is blocked. Especially the pipeline of the linear edging machine is easy to be blocked by the bristles, and it is not easy to be noticed after blocking, which will cause insufficient cooling and affect the quality of edging.

4. The CVT used by the edging machine must be in the open state when adjusting the speed, otherwise the CVT of the edging machine will be easily damaged.

—All the following preparations have been made in advance, and there may be other factors:

1. Manufacturing (process) factors, although the design is correct, but the manufacturing conditions cannot meet the design requirements, and various difficulties in the equipment cause the effectiveness of the device. Such as cracks in the forging process; incomplete penetration in the welding process, loosening and slag inclusion caused by cold and hot cracked casting: the dimensional tolerance and surface roughness of machining are not suitable; defects in the heat treatment process, such as quenching cracks, tempering embrittlement , The structure defect of the hardened surface layer, insufficient hardness, too thin hardened layer; finishing grinding cracks, etc.

2. There is a problem with the quality design of the glass edging machine. For example, although the process of the edge grinding machine is reasonable, because the manufacturing conditions cannot meet the design requirements, various failures of the equipment will lead to failure. In the forging process, the crack welding process is not in place, hot and cold cracked castings, porosity, slag inclusion; machining tolerances and surface roughness are inappropriate" defects in the heat treatment process, such as cracks, tempering, and hardened surfaces The sinking, hardness, hardened layer is too thin; fine grinding cracks.

3. The material selection factors of the edging machine, the materials used in the parts of the equipment do not meet the technical conditions, and the internal sinking of the material is essentially the source of internal stress concentration. Under the action of external load, the material lacks filling and presents high stress, which leads to some kind of failure. The key effect caused by the material may be due to improper design and material selection; it may also be caused by defects in the process of cold and hot processing (especially heat treatment) of the blank, and due to improper installation and debugging.

4. The factors of machine operation and maintenance, first of all, are the monitoring of the operating conditions (load, speed, etc.) of the machine to see if it meets the specified requirements. In addition, lubrication conditions are also an important factor. Lubrication conditions usually include: Whether the lubricant and lubrication method are selected properly, whether the lubrication device and the cooling, heating and filtering system function normally. This is also a daily maintenance problem for a glass edging machine. NS.