Analysis of the problems that should be paid attention to in the operation and use of CNC glass special-shaped edging machine

1. Start the blower, then start the heater. Instead, turn off the heater first, then the blower. There can be no problems with this order, otherwise it will cause serious production accidents.

2 Check the piping system for leaks. If this occurs, notify service personnel for repairs.

3. Start the machine for no-load test run, check whether the glass cleaning machine is running normally, everything is normal before the glass cleaning operation.

4. For the special-shaped edging machine that has just been started, remove the oil slick, because the water pump has not been turned on at this time, the oil removal effect is better.

5. Check if there is enough cleaning fluid. If it is not enough, the cleaning solution must be added in time to prevent the glass washer from being scrapped.

6. During the operation of the special-shaped edging machine, feed the material to a certain extent, and do not overload the glass washing machine. If the thickness of the glass after cleaning changes, the air knife should be adjusted in time to avoid unnecessary losses.

As an indispensable machine for glass processing, CNC glass special-shaped edging machine has always occupied a large space for use in the glass processing industry, but many glass processing enterprises are not standardized for the normal operation and use of glass washing machines, so these precautions must be To clearly remember, so as to extend the life of the equipment.