How should the glass edging machine be used?

With the development of science and technology, people can not only give full play to the natural advantages of glass, but also adjust its performance to make up for its defects.How should the glass edging machine be used, and what processes do you need to go through to make your own glass, let's take a look.

1. Precautions when using the glass linear edging machine:

The working method of linear edging machines (straight edge machines, round edge machines, bevel edge machines) is to clamp the glass through the front and rear pressure plates and drive its linear motion for grinding.Two points must be paid attention to in use: ①the binding surface of the front and rear pressure plates and the guide rail should be refueled and lubricated frequently, otherwise it will affect the normal service life of the machine due to premature wear of the front and rear pressure plates and the working surface of the guide rail.Although some models have automatic lubrication devices, they should always check whether the lubrication pipeline is smooth; ②The clamping force should be appropriate when clamping the glass. Too loose affects the grinding quality, and too tight will increase the load on the machine, which is prone to shaking and crawling, and it is easy to break the glass when grinding thin glass.The size of the clamping force can be tested with a slightly larger piece of glass clamp on the machine, that is, clamp the glass in the middle of the machine, and move the glass vigorously with both hands during shutdown. It feels that the clamping force is adjusted to just when the hands cannot move. It is appropriate.

2. Precautions when using glass special-shaped edging machine

①The consistency of the height of the suction cups on the workbench of the special-shaped machine has a greater impact on the grinding effect.During assembly, the manufacturers have self-ground the five sets of suction cup holders, and selected suction cup glue of the same thickness to keep the height of each suction cup consistent. Therefore, under normal circumstances, do not disassemble and assemble the suction cups.If the suction cup glue is damaged, choose the one with the same thickness to replace it.②The vacuum pump of the special-shaped machine will be used for a period of time, and the vacuum degree will decrease (that is, the suction power will decrease) due to water inlet and other reasons. Therefore, attention should be paid to checking and troubleshooting. Otherwise, the machine will work under insufficient suction. On the one hand, it will affect the grinding quality, and on the other hand, it is also prone to safety accidents.

3. Precautions when using bilateral edging machines

①The bilateral edging machine is a lower-level edging machine. It is recommended to fix two to three people to operate it when using it to ensure correct operation.② When there is an error or failure in the procedures of bilateral grinding, it is recommended to ask the original manufacturer to send someone to repair and debug. Under normal circumstances, do not disassemble and repair, so as not to mess with the procedures and cause shutdown.

4. Precautions when using the mold machine

①the mold relying on the touch machine has a great impact on the grinding accuracy.The working surface relying on the template must be made with accurate shape and size, and the finish should be high.If the special-shaped shape depends on the template, the transition must be smooth.②When replacing the template and suction cup, be sure to maintain the level of the working surface of the suction cup, otherwise it will affect the grinding quality.

In addition to the edging machines described above, there are also some edging machines with simple structure and single purpose, such as chamfering machines, small disc machines, polishing machines, etc.There are also some special edging machines that specialize in processing certain products, such as car rearview mirror edging machines, wash basin edging machines, etc.